MesoWest Information for SE398 in SCE Lucerne Valley, CA, United States Of America (site inactive)
The following information is known about SE398. If you think that any information is incorrect,
then please follow the instructions for correcting that data item.
It is possible that this page will report a problem where no problem exists. If you believe that
this has happened, then please contact me (address at the bottom of this page) and explain clearly
why you think this page is in error. Note that any changes that you make may take a few days to show up here, so
please give it a week before commenting.
Latitude: 34° 25' 43" N (deg min sec), 34.4287° (decimal), 3425.72N (LORAN) Longitude: 116° 48' 21" W (deg min sec), -116.8058° (decimal), 11648.35W (LORAN) Elevation: 944 metres (3097 feet) -- validated against 936 metres (3071 feet) from Geonames Location: SCE Lucerne Valley, CA, United States Of America County: San Bernardino, CA
Data provider: SC-EDISON
Forecast Offices: Las Vegas (VEF), San Diego (SGX), Phoenix (PSR)
The site location should be at the mark shown -- or very close. Clicking within the map area (or you can drag the 'SE398' marker) will display the latitude/longitude of that point.
If the displayed location (or elevation) of the weather observing location is incorrect, please drag the marker to the right location (or click in the right location), and then send the updated information.
Please note that we are trying to spot either the Stevenson Screen (or equivalent) or the location where the barometric readings are taken.
Can you help with location quality? Please indicate
if the marker on the map points at the weather instrument cluster:
The location information for this site was gathered from 1 data source. The source which most closely matches the consensus is chosen. Many of these sources
only report the location to the nearest minute (or hundredth of degree). This can lead to the marker being placed noticeably incorrectly. Please see Discussion of Location Errors for more information.
The position of the clicked point on the map is:
The position of the 'SE398' marker on the map is:
Latitude: dummy (deg min sec), dummy (decimal), dummy (LORAN)
Longitude: dummy (deg min sec), dummy (decimal), dummy (LORAN)
Estimated elevation is dummy metres (dummy feet) from dummy.
Location is dummy (reverse geocoded).
Move marker to new address.
There are no photographs of the station. If you have pictures of this location,
then please email them to se398@photo.gladstonefamily.net.
Picture Submission
There are two ways to submit pictures. If you are a flickr user, then see the flickr section below. Otherwise you can simply email the pictures as follows:
If you use a smartphone that embeds the GPS coordinates in the pictures, then you can send any picture of a weather station to gps@photo.gladstonefamily.net and it will be associated with the correct station automatically.
Flickr Upload
Uploading picktures to flickr.com is easy. If you do not have a free flickr account, then you need to create one. Just go to flickr and click the 'Create your account' button. You can use a google account if you have one.
Once logged in, click on 'Upload Photos & Video'. Next click on 'Choose Photos and Videos', and walk through the process to upload your pictures. They will automatically be resized appropriately.
After the upload is complete, it will ask you to add titles, tags and descriptions. The key step is to add tags as follows:
wxtagged -- this indicates that this picture is of a weather station or surrounding area
wx:id=se398 -- this indicates the site of which this is a picture
wxstation -- add this tag if the picture includes the weather station.
If you had to create your account, then you must upload at least five pictures. It will also take longer for your pictures to appear (a week or so). Otherwise, the pictures should appear after 24-48 hours.
You can try to find photographs from the area surrounding the site marker by clicking on Find nearby photographs.(There are some)(There are none)(There may be some)(Automatically loaded if any)
Status: Status: None found.
Clicking on the map above will redo the search centered on the clicked point.
Status: 3 found.
If any images are of the weather station, then please click on those images, and add the 'wxtagged' and 'wx:id=SE398' tags to those images. For the station itself, please add the 'wx:station' tag as well.
Some users do not permit other users to add tags to their images. In these cases, just add a comment to the picture asking the photographer to add the tags themselves.
Clicking on the map above will redo the search centered on the clicked point.
You can try to find photographs from the area surrounding the selected point by clicking on Find nearby photographs.
NOTE: If the error above is POSITIVE, then it means that the analysis temperature is HIGHER than the reported temperature.
This means that your sensor is reading COLDER than expected.
MADIS rating
Latest daily graph:
Your readings are not within an acceptable error range. The automated problem analysis cannot identify the problem. You can signup on the wxqc mailing list and post information about this situation there. This is may be caused by poor siting of the sensor (e.g. under eves, in screen porch, or in thick tree coverage). For information on siting, see CWOP Station Guide.
NOTE: If the error above is POSITIVE, then it means that the analysis temperature is HIGHER than the reported temperature.
This means that your sensor is reading COLDER than expected.
MADIS rating
Latest daily graph:
These values are within the acceptable range. This probably means that your sensor is sited correctly and is calibrated correctly.
The wind vector is the average wind over the relevant period. Note that if the wind blows North for half the time at 2 knots, and then blows South for the other half of the time at 2 knots, then the result is zero -- i.e. North wind and South wind will cancel out.
Over time, the direction of the wind and of the analysis should match pretty well. If the lengths of the vector are different, then it could mean either that your anemometer reads high or low, or that you are in a more shielded or more open space.
MADIS rating
Today
Last 7 days
Neighboring Stations
This is a list of stations that are close to this station.
Note that this is not the list of stations
that are used in the data analysis. That list of stations is known only to MADIS.
You can see all the stations at MADIS Data Display. Your station should be in the middle of the display.
If you think that the analysis is incorrect, then maybe one of the close stations has failed.
You can look at those for comparison purposes.
The average difference between your station and each station below is listed as well. This may allow you to detect local
stations which are erroneous. You can also use these numbers to adjust your instruments -- especially if a number of ASOS stations
have similar differences to your station. Also, try increasing the analysis period to more than the default 28 days.
The difference is only given if both stations report reasonably often during each day. Some stations
only report every 6 hours, and this makes the average of less interest. In this case, the average is not displayed.
The values reported are the differences between this station and the neighboring station. I.e. if the difference is positive, then this station is reading higher than the neighboring station.
Since this station has not been reporting continuously during the analysis period (it missed 17 days out of 28), the offsets below may not be accurate.
YUCCA VALLEY, CA, US (lat 34.1615°, long -116.3535°, altitude 968 metres)
5.9°F
-4.8°F
The sites marked above thus did not report continuously during the analysis period, so the offsets may (probably will) not
be accurate.
Quality Control Notes
This page reports on the quality control checks performed by MADIS. The green check mark and red cross are chosen based
on the average performance during the analysis period (which is selectable above). The red cross can appear even if
MADIS reports that all observations pass the MADIS QC checks.
The 'MADIS rating' reports on the percentage of observations that pass the MADIS checks. You should aim for two thumbs up!
Location Formats
The location is shown in three different formats. Each of these is used in some software, and is shown on some websites.
Overall website comments, problems etc to Philip Gladstone Page layout last modified Sunday, 28 February 2016
This page is one of 106224 similar pages. This one was generated in 0.58 seconds.
or
250 miles 
